3 Amps of musicality
Ranging from 5 to 19 V, this small package carries a big punch over the full bandwidth with an incredible low noise floor
Read more about the Super3 TMCB upgrade or retro-fit
Here's where it comes from...
A well designed circuitry, smart PCB design, grade A components, a sturdy aluminium housing and the drive to bring out something special in any sound system make up for a nifty and potent supercapacitor linear power supply with a very small footprint that will find a place in even the smallest of environments.
There is more to it!
It’s not a case of throwing in some premium components and expect instant succes. They need to work in harmony to get an optimal result. It all starts with a clear concept of goals, how to achieve them, and painstaking testing: by measurements and by many hours of listening.
"This rightness was a perfect example of the whole is greater than the sum of its parts."
"The Farad Super3 is clearly a first rate power supply upgrade"
"The precision, clarity, and freedom of the sound clearly exceed what has previously been achievable"
Anatomy of your Super3 Power Supply
What makes the Super3 stand out from the others
Hf Pi-filter smoothing section
Low ESR capacitors and Hf common mode choke filtering reduce ripple and Hf noise from mains and rectifiers. In total there are 6 pi-filter sections in a Super3 to reduce Hf noise to a minimum before and after regulation. Low frequency noise (ripple) is fully eliminated by the double regulation and supercapacitors.
AC Inlet, Fuse & Fuse holder
From a Furutech Rhodium AC inlet to a gold plated fuse in a holder with gold plated contacts... Better conductance from point zero onwards leads to better performance.
Super Capacitor Power Bank
Supercaps tuned to the voltage of the power supply provide a capacitance of 1F (1.000.000uF) to 3.3F (3.300.000uF), depending on voltage. This bank acts like a virtual battery, supplying the final low noise regulation with total stable clean input power. All this results in pure dc voltage with the lowest noise floor thinkable over the full bandwidth.
Custom wound transformer
Casted triple shielded mil-spec high-inductance transformer for high supply duty cycle (and low rectification noise) and very low AC leakage current.
Voltage change service
Depending on the initial output voltage from your power supply, we can change the output voltage in our workshop. Since each supply is fully optimized to its specific voltage, both the supercap module and mains transformer need to be replaced for this change.
More information about a voltage change
If all of this didn’t convince you, have a look what others have to say about the Super3 – here
Super3
NOTICE: Due to popular demand TMCB 100Vac and 115Vac are OUT OF STOCK until END OF MAY 2026. You can request a 100Vac or 115Vac TMCB upgrade by emailing us at [email protected]
Configure your Super3 in four easy steps for AC mains, DC Output and DC Connector type, as well as upgrades for your Super3 with audiophile fuses, DC Output cables and an AC cable. If in doubt about the output voltage connector type or if your connector type is not included, please look at the confirmed loads page or send us an e-mail.